Cause
During a boot, this error is displayed and the multicast is not configured.
Action
An inittab(4) from a previous release of the operating environment was used.
Thus, the following entry, which is required for the route command in the Solaris
2.6 release, was missing from /etc/inittab.
ap::sysinit:/sbin/soconfig -f /etc/sock2path
By default, this is the second entry in the file. After this entry was added, the
multicast configured at boot time without error.
Cause
The save fails with this error because the database (index) file for the client is greater
than 2 Gbytes. With the Solaris 2.6 release and SBU 5.0.1 this is no longer a problem.
Action
However, with earlier versions of the Solaris software you need to open nwadmin ->
indexes -> select appropriate client -> select appropriate fs -> remove oldes cycle ->
reclaim space.
You might have to repeat a few times to reclaim enough space. The indexes can be
re-created later, if necessary, by using a scanner.
During a boot, this error is displayed and the multicast is not configured.
Action
An inittab(4) from a previous release of the operating environment was used.
Thus, the following entry, which is required for the route command in the Solaris
2.6 release, was missing from /etc/inittab.
ap::sysinit:/sbin/soconfig -f /etc/sock2path
By default, this is the second entry in the file. After this entry was added, the
multicast configured at boot time without error.
save: SYSTEM error, Arg list too long
Cause
The save fails with this error because the database (index) file for the client is greater
than 2 Gbytes. With the Solaris 2.6 release and SBU 5.0.1 this is no longer a problem.
Action
However, with earlier versions of the Solaris software you need to open nwadmin ->
indexes -> select appropriate client -> select appropriate fs -> remove oldes cycle ->
reclaim space.
You might have to repeat a few times to reclaim enough space. The indexes can be
re-created later, if necessary, by using a scanner.
No comments:
Post a Comment